Light intensity in the aviation obstruction light how to install

Intensity obstacle lights in about how to install, until hin technology small make up method to share with you, can be divided into two steps, it is to embed line pipe; The second is with the line pipe.

A, embed line pipe, namely wire diameter and number of embedded according to need not be less than & Phi; 25 obstacles lights line pipe to desired location.

Second, with the line pipe, according to the requirements of design online tube wear into the wire, using a fixed screw base or the use of expansion bolts. According to the wiring diagram wiring and connect the ground lightning protection network. In the process of installation, it is important to note that the aviation obstruction light for GPS satellite wireless control aviation obstruction light outside to search for the satellite signal about a minute before normal work.

Three, installation considerations

Aviation obstruction light should be installed in the lightning protection zones, obstacles around the lamp should be no other light interference, the shell should be reliable grounding. System installed, should carefully check all wiring is correct and reliable, good line insulation, determine and correct rear can electricity debugging. When debugging work during the day, but will photosensitive hole cover with black object, after a few seconds, the red signal indicator on the controller panel should be light, observation obstacle lights should be according to the prescribed frequency flash work; When remove the obstructions, obstacle lights should stop working. If discover fault indicator light display light, should check whether the lamps and lanterns should further work normally, such as fault lamps and lanterns should promptly notify the professional maintenance.